Volkswagen Drive Cycle Procedure: Emissions Test

🚗The Volkswagen drive cycle procedure helps set the necessary monitors for a successful emissions test.

🔍Before starting the drive cycle, make sure the check engine light is off and there are no stored or pending codes.

⏰Timing is crucial during the drive cycle, so follow the instructions carefully and maintain the specified speeds for the required durations.

🚦Avoid sudden acceleration, sharp turns, and braking during the drive cycle to ensure accurate monitor readings.

🔒After completing the drive cycle, check the readiness monitors using an OBD2 reader to ensure all necessary monitors are set.

What is the purpose of the drive cycle procedure?

—The drive cycle procedure helps set the necessary monitors in the vehicle's onboard diagnostics system for an emissions test.

Why is it important to ensure the check engine light is off?

—The check engine light indicates a potential issue with the vehicle, and if it's on, the monitors may not run properly during the drive cycle.

What should I do if a monitor doesn't set after completing the drive cycle?

—If a monitor doesn't set, you may need to repeat the drive cycle procedure multiple times to ensure all monitors are ready for the emissions test.

Can I use cruise control during the drive cycle?

—No, it's recommended to avoid using cruise control during the drive cycle to ensure accurate monitor readings.

How can I check the readiness monitors after the drive cycle?

—You can use an OBD2 reader to scan for readiness monitors and check if all necessary monitors are set.

00:00Introduction to the Volkswagen drive cycle procedure for emissions testing.

02:39Explanation of the OBD2 system and the importance of a coal start.

04:21Step-by-step instructions for completing the drive cycle.

08:00Technical parameters and precautions for the drive cycle procedure.

11:11How to check the set monitors and ensure readiness for the emissions test.